[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
Re: [sumo-user] [EXTERNAL] Re: capacity analysis
|
Possibly yes, but I'm not sure. You could try to consult the original model author (Kallirroi Porfyri) or dig into the publications on which the model was based.
This would indicate that the default values for ACC and CACC given here,
Definition of Vehicles, Vehicle Types, and Routes - SUMO Documentation (dlr.de) are extremely situation specific and I would have to reconsider these values. Would that make sense?
Regards,
V.H.Pradeep
**EXTERNAL EMAIL**
This email originated outside of The University of Texas at San Antonio.
Please exercise caution when clicking on links or opening attachments.
|
Please be aware that 'ACC' and 'CACC' are just one possible implementation of (cooperative) automated cruise control.
They are not the "definite" models for these things.
If the models behave differently from your expectations, this may reflect the very specific situations they were calibrated for by the original model authors.
In my own tests, I observe that the capacity of 100% CACC with tau=0.6 is up to 16% higher compared to the default. However, this is heavily influenced by the choice of insertion speed value (with values 'desired' and 'avg' performing well
and value 'max' performing far worse than the default model.
I suggest that you do your own parameter calibration until the observed results reflect your expectation.
To model different reaction times, use different actionStepLength values for the different types.
Hello ,
I am analyzing a freeway section and trying to implement the ACC and CACC model in my simulation. I observed that as the number of vehicles with ACC and CACC model increased the
capacity of freeways started to decline and it was lower than the manual driven vehicles. I have given Tau as 0.6 for CACC vehicles and 0.9 for ACC vehicles , correspondingly I reduced the simulation step length as well to 0.1. I wanted to know two things
here how do I implement the reaction time for ACC or CACC vehicle say 0.1 sec and should I use the simulation step length as 1 and use the action step length for a particular vehicle type to improve the speed of simulation. Further why is my capacity decreasing
even with ACC and CACC modes?
Regards,
V.H.Pradeep
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user