Re: [sumo-user] Queue in MESO GUI

[Sasan Amini <aminissn@xxxxxxxxx>]

thanks, that actually helps to understand the variables. I just added
a comment on an issue on Github, would it be possible to get MESOGUI
outputs in edge-outputs?
https://github.com/eclipse-sumo/sumo/issues/14682#issuecomment-2467950021

On Mon, Nov 11, 2024 at 12:13 PM Jakob Erdmann via sumo-user
<sumo-user@xxxxxxxxxxx> wrote:
>
> 'queue' corresponds to lane index in the microsim (most edge segments works like a single queue by default, but if you use --meso-lane-queue then each segment has as many queues as it has lanes). The value does not correspond to the number of queued vehicles.
>
> Am So., 10. Nov. 2024 um 21:44 Uhr schrieb Sasan Amini via sumo-user <sumo-user@xxxxxxxxxxx>:
>>
>> Dear all,
>>
>> I was trying to analyze queue length in mesoscopic simulation with the
>> a recent nightly build (Version v1_21_0+0603-0949a42256f). I can get
>> "ueue in FCD-output, but I am not sure if the value is reported
>> correctly. Here is a screenshot of a scenario. The selected car is
>> traveling with free-flow speed but in GUI it says it is in queue index
>> 2. Maybe the definition behind queue is a bit unclear to me. The edge
>> output also shows that this edge has 3 queue segments but there are
>> only 2-3 cars on that edge. Not sure how these variables are defined.
>> I would very much appreciate any clarifications.
>>
>> Best,
>> Sasan
>> _______________________________________________
>> sumo-user mailing list
>> sumo-user@xxxxxxxxxxx
>> To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
>
> _______________________________________________
> sumo-user mailing list
> sumo-user@xxxxxxxxxxx
> To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user