[sumo-user] Speeds in Curves

[Pedro Oliveira <pedro.engenhariae@xxxxxxxxx>]

Good morning!

I would like to check if SUMO has any speed restrictions for curved sections. We have a winding section where we would like to incorporate a speed reduction.

Our speed measurements were on straight sections, but one of the points was near a curve where we felt there might be speed reductions.

Watching the simulations in by-speed vehicle mode, we see that there is no significant speed reduction, so we would like to add some parameter that would reduce speeds.

Thank you in advance for your attention.

Não contém vírus.www.avast.com