Re: [sumo-user] How to simulate blinking yellow/blinking red.

[Jakob Erdmann <namdre.sumo@xxxxxxxxx>]

See the updated documentation here: https://sumo.dlr.de/docs/Simulation/Traffic_Lights.html#switching_tls_off

o/O also take into account left turns yielding to oncoming traffic.

The release version only supports the mode where some directions have priority ('O') but not the mode where all directions have to stop.

However, the latter mode is available in the development version.

regards,

Jakob

Am Di., 15. Nov. 2022 um 04:20 Uhr schrieb Nine, Harmon S via sumo-user <sumo-user@xxxxxxxxxxx>:

Hello.

I've read the sumo manual on traffic lights (https://sumo.dlr.de/docs/Simulation/Traffic_Lights.html), but it's not clear how to simulate a signal that is:

• blinking yellow in one direction and blinking red in the orthogonal direction, or
• blinking red in all directions

Would "blinking yellow in one direction and blinking red in the orthogonal direction" use "o" in the blinking-red direction and "O" in the blinking yellow direction?

Also, do "o" and "O" take into account vehicles that are turning left, and that they have to yield to oncoming traffic?

Thanks 🙂

-- Harmon

_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user