| Re: [sumo-user] Spawning and moving pedestrians in SUMO |
Hi Mirko, dear Michael,
thanks for the hint.
The C++ implementation inside the TraCI C++ API has been quite forward and intuitive.
The problem arises, if the person is spawned and then shall be moved freely:
Apparently, the pedestrian is initialized with the state WAITING_FOR_DEPART, which causes the following error, when trying to move the person in the same time step:
>> Command moveToXY is not supported for person 'my_pedestrian' while waiting (awaiting departure).
So, I append an additional walking state with a pseudo route via PersonScope::appendWalkingStage(), and then afterwards execute PersonScope::moveToXY().
But then, although calling PersonScope::moveToXY() every simulation cycle before step() I obtain the following warning after 2 simulation cycles:
>> Person 'my_ped' was removed though being controlled by TraCI
My goal is to move the pedestrian completely free in the scene via TraCI. So, are there any constrains I might neglect?
BR,
Marc
Hi Marc,
I haven't had a look on the server side, but if the Python API works, there is no reason a C++ API implementation should not. You can start from C++ vehicle.moveToXY() and adjust the message components from there (remove lane ID from the message, change the scope).
Mirko
Am 06.10.2019 um 14:20 schrieb Marc Zofka:
> Dear Michael,
>
> thanks for your response. Considering your reference [1], the python interface seems to support the movetoXY() capability for persons, whereas it is not supported by the C++ TraCI class (TraCIAPI.h). I assume, that is should be sufficient to adapt the vehicle scope's method moveToXY() to the person scope? Is the TraCI Server supporting this capability?
>
> With best regards,
> Marc
>
> [1] https://sumo.dlr.de/pydoc/traci._person.html
>
>
>
> Hi Marc,
> to get an overview of what is possible with persons just look at https://sumo.dlr.de/pydoc/traci._person.html.
>
> Best regards,
> Michael
>
> Am 2019-08-02 11:06, schrieb Marc Zofka:
>> Dear Sumo-Users,
>>
>> is there a way to spawn and control pedestrians using TraCI
>> programmatically? I would also appreciate if there are some hints on
>> the wiki. Unfortunately, I could find any hints wrt. pedestrian
>> control over TraCI except that vehicles can be moved externally.
>>
>> With best regards,
>> Marc Zofka
>>
>> _______________________________________________
>> sumo-user mailing list
>> sumo-user@xxxxxxxxxxx
>> To change your delivery options, retrieve your password, or
>> unsubscribe from this list, visit
>> https://www.eclipse.org/mailman/listinfo/sumo-user
> _______________________________________________
> sumo-user mailing list
> sumo-user@xxxxxxxxxxx
> To change your delivery options, retrieve your password, or
> unsubscribe from this list, visit
> https://www.eclipse.org/mailman/listinfo/sumo-user
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To change your delivery options, retrieve your password, or unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
_______________________________________________
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To change your delivery options, retrieve your password, or unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user