4Diac Forte and STM32 [message #1819335] |
Mon, 13 January 2020 12:53 |
|
Hi, I want to design a PLC using the STM32F103 (Bluepill board) or NUCLEO-F401RE board.
I saw here many topics on STM32 but I can not find a starting point how to implement step by step my project. I also have installed Eclipse for STM32 in Linux and 4DIAC as well.
Since I am a CODESYS programmer I can easily learn IEC 61499 model.
I suppose after building the program on 4Diac editor I need some Board Pins Description and some libraries to make the run time specific firmware using FORTE. But how all that is implemented on STM32?
So please anyone can give me a jump start documentation on what is needed to implement STM32 on these boards I will be greatly appreciated.
Thanks a lot
|
|
|
|
Re: 4Diac Forte and STM32 [message #1819561 is a reply to message #1819426] |
Fri, 17 January 2020 10:49 |
|
Hi Jose,
You gave me the motivation and the starting point I needed. Being a DOS and Z80 person since early days I can imagine what my road to importing code to STM32 might look like.
I know, a hard work and a lot of reading waiting for me but I am confident that people can be found here to help me so and then I can share my experience to others.
So far :
1 - I have installed 4DIAC and made the blinking example flowing the 4DIAC documentation (as an emulation not as an embedded device).
2 - I am installing all the tools (IDE Eclipse, STM32CubeMX, STM32 ARM tool-chain, etc) for writing STM32 firmware.
3 - I am reading for FreeRTOS + lwIP as well to understand it and how to run it on my STM32 devices.
4 - Then comes the I/O configuration..
A lot of work and I am preparing one step at a time
It could be nice if others have moved towards STM32 board implementations it is good to have their opinions.
I am thinking after my attempt on 4DIAC + STM32 finally to have results then write some clear notes and publishing them here, so others can benefit from my experience.
Thanks again you and everybody else how wants to write his experience here so to have a starting point concerning 4DIAC + FORTE + STM32
[Updated on: Fri, 17 January 2020 12:12] Report message to a moderator
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03660 seconds