| Re: [sumo-user] Flows causes only one vehicle to be running in the simulation |
_______________________________________________Hi Jakob,
Thanks for your quick reply. I have the length of the road set to 5000 m.
Thank you
Best Regards
Aashik Chandramohan
From: Jakob Erdmann
Sent: 25 March 2019 11:22
To: Sumo project User discussions
Subject: Re: [sumo-user] Flows causes only one vehicle to be running in the simulation
Most likely your road is shorter than 28m which means the first vehicle has exited by the time the second vehicle can be safely inserted.
- Make your road longer- add the flow attribute departPos="last" to get the minimum spacing between the vehicles on insertion
Am Mo., 25. März 2019 um 11:10 Uhr schrieb <a.chandramohan@xxxxxxxxxx>:
_______________________________________________Hello All,
I am trying to generate random departure times using flows. However I would like the vehicles to depart with a certain departSpeed.
Hence I have added flow statement as shown below:
<flow id="car" departSpeed="13.89" color="255,0,0" begin="0" end= "10000" probability="0.5" type="Car">
<route edges="Road"/>
</flow>
However, I get only one vehicle to be running In the simulation. The next vehicle starts only after the first vehicle exits the simulation.
The simulation however works fine if I do not use the departSpeed, but I would like the vehicles to start at 13.89m/s. Hence could any of you advice me on a way to do that?
Thanks for your help
Best Regards
Aashik Chandramohan
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To change your delivery options, retrieve your password, or unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user
sumo-user mailing list
sumo-user@xxxxxxxxxxx
To change your delivery options, retrieve your password, or unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user