Hello,
I hope this email finds you well. I am writing to seek assistance regarding an issue I encountered while using the Sumo simulation tool.
I successfully generated an edge-based state dump output by entering the command "--edgedata-output <FILE>" in the command line. The output was produced correctly. However, when I attempted to output data for a specific time range by specifying the time using the additional attributes -b (--begin) and -e (--end), the results were not as expected. I noticed that setting the begin parameter to 0 resulted in the correct output, but I require the output for the specified time range.
I would greatly appreciate it if you could provide guidance on how to correctly output the data when the begin parameter is set to a value other than 0, ensuring that it corresponds to the desired time range.
<!-- generated on 2023-06-12 15:33:24 by Eclipse SUMO sumo Version 1.16.0
<configuration xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:noNamespaceSchemaLocation="http://sumo.dlr.de/xsd/sumoConfiguration.xsd">
<input>
<net-file value="manhattan.net.xml"/>
<route-files value="sumotest.trips.xml"/>
</input>
<output>
<edgedata-output value="edge_test.xml"/>
</output>
<time>
<begin value="34000"/>
</time>
<report>
<no-step-log value="true"/>
</report>
</configuration>
-->
Thank you for your attention to this matter. I look forward to your prompt response.
Yours sincerely,
Yuji
