Re: [sequoyah-dev] Debugging native code

[Daniel Pastore <kpqb38@xxxxxxxxxxxx>]

Hi Jean,

have you checked the new NDK guide to see if your steps are correct/in the correct order?

http://wiki.eclipse.org/Sequoyah/ndk_guide

On Thu, Feb 24, 2011 at 00:19, Jean-Yves Avenard <jyavenard@xxxxxxxxx> wrote:

Hi there.

I had paused a particular project for about 3 months now ; and I
restarted eclipse and my android development environment.

For some reasons, I can not get native code debugging working. I have
my breakpoint in the C++ code : but it just won't stop there. This is
using either the simulator or an HTC desite

Compiling, installing, all is fine... Just can't debug.

I have to admit that my memory is a tad blurry on what I did to make
it run in the past.
The sequoyah pluging is I believe properly configured (and didn't
change since I last got it going).


Any pointers on where I should be looking at ?

Thanks
Jean-Yves
_______________________________________________
sequoyah-dev mailing list
sequoyah-dev@xxxxxxxxxxx
https://dev.eclipse.org/mailman/listinfo/sequoyah-dev

--
Thanks,

Daniel Pastore

Sequoyah Team