[
Date Prev][
Date Next][
Thread Prev][
Thread Next][
Date Index][
Thread Index]
[
List Home]
Re: [m2e-users] where is settings.xml?
|
m2e uses proxy configuration from settings.xml, same as maven on command
line. I believe in most cases the same system will be used to run both
m2e and command line builds, so use of the same configuration file is
the only option to keep the two builds consistent. I am not sure if
there is a good solution for your case, but I am open for ideas (and no,
new workspace preference is not a good solution).
--
Regards,
Igor
On 12-11-28 9:48 AM, Ilko Iliev wrote:
Hi Igor,
we have to config proxy and these are the only settings set in
settings.xml - how it is supposed to correctly handle this situation?
Manually copy settings.xml was the only remedy for us, but this is
somehow ugly, especially on several installations. Perhaps it is
possible to use the network settings as set in RAD / Eclipse?
Just to correct myself - build loop was wrong - the process hung on
accessing the central maven repo and after we copied the settings.xml to
the default location the build went further.
TIA,
Ilko
On Wed, Nov 28, 2012 at 3:03 PM, Igor Fedorenko <igor@xxxxxxxxxxxxxx
<mailto:igor@xxxxxxxxxxxxxx>> wrote:
settings.xml is optional. When this configuration file is not pressent
m2e (or maven for that matter) will use default values for location of
local repository, http proxies and other settings.xml parameters.
Endless build loops usually mean either workspace got out of sync with
local filesystem or incompatible maven plugins are forced in m2e
workspace build.
--
Regards,
Igor
On 12-11-28 8:51 AM, Ilko Iliev wrote:
Hi,
perhaps a stupid question, but I have the dead lock situation
with m2e
and RAD 8.5 and I assume the problem is that there is no
settings.xml
file on the machine, because it does not have apache maven installed
onto it. So in the preferences there is a warning "Missing
settings.xml", which is correct, however the build process goes
into a
never ending loop, trying to access the maven repo causing the
RAD to
crash completely. My question is, if there is settings.xml
generated /
installed with the installation of the m2e plugin and if yes
where could
I find it / why it is not set as default from the installation
procedure? I haven't found some prerequirements on the plugin
page that
maven installation is needed on the machine - as far as I can
remember
somewhere is a statement "you don't need local maven
installation with
the plugin because the internal will be used" - or something
similar.
TIA,
Ilko
_________________________________________________
m2e-users mailing list
m2e-users@xxxxxxxxxxx <mailto:m2e-users@xxxxxxxxxxx>
https://dev.eclipse.org/__mailman/listinfo/m2e-users
<https://dev.eclipse.org/mailman/listinfo/m2e-users>
_________________________________________________
m2e-users mailing list
m2e-users@xxxxxxxxxxx <mailto:m2e-users@xxxxxxxxxxx>
https://dev.eclipse.org/__mailman/listinfo/m2e-users
<https://dev.eclipse.org/mailman/listinfo/m2e-users>
_______________________________________________
m2e-users mailing list
m2e-users@xxxxxxxxxxx
https://dev.eclipse.org/mailman/listinfo/m2e-users