Thanks for your valuable suggestion 
  
  
 
 
From:
gef-dev-bounces@xxxxxxxxxxx [mailto:gef-dev-bounces@xxxxxxxxxxx] On Behalf Of Abdelmounem EL MOUDEN 
Sent: Tuesday, June 24, 2008 6:52
PM 
To: GEF development 
Subject: Re: [gef-dev] how to drag
figure vertically but not horizontally 
 
  
In the action
implementing the drag event set only the Y location and keep the old X. 
2008/6/24 <Shalaj.Shukla@xxxxxxxxxxxxxxxxxx>: 
 
Hi 
 
Is it possible to drag the draw2d figure only vertically but not 
horizontally on canvas? 
 
Regards, 
 
Shalaj Shukla 
 
 
 
DISCLAIMER: 
This message contains privileged and confidential information and is intended
only for an individual named. If you are not the intended recipient, you should
not disseminate, distribute, store, print, copy or deliver this message. Please
notify the sender immediately by e-mail if you have received this e-mail by
mistake and delete this e-mail from your system. E-mail transmission cannot be
guaranteed to be secure or error-free as information could be intercepted,
corrupted, lost, destroyed, arrive late or incomplete or contain viruses. The
sender, therefore,  does not accept liability for any errors or omissions
in the contents of this message which arise as a result of e-mail transmission.
If verification is required, please request a hard-copy version. 
_______________________________________________ 
gef-dev mailing list 
gef-dev@xxxxxxxxxxx 
https://dev.eclipse.org/mailman/listinfo/gef-dev 
 
  
 
DISCLAIMER: This message contains privileged and confidential information and is intended only for an individual named. If you are not the intended recipient, you should not disseminate, distribute, store, print, copy or deliver this message. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete or contain viruses. The sender, therefore, does not accept liability for any errors or omissions in the contents of this message which arise as a result of e-mail transmission. If verification is required, please request a hard-copy version.
  |