Skip to main content

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [List Home]
[emf-dev] Vote for Committer status for Dennis Huebner was started by Ed Merks

modeling.emf Committers,
This automatically generated message signals that Ed Merks has nominated
Dennis Huebner as a Committer on the modeling.emf project. The reason given
is as follows:

Dennis has been  helping set up the build for Xcore.  He's pretty much
down, but without committer access he can't easily maintain our builds and
can help with promoting builds.  He's also planning to look into setup up
our builds to work with Eclipse 3.5 so that we'll be inserting more
flexible lower bounds into the results of our 2.8 builds.

Note that committers who don't vote will most likely be decommitterized.

The vote is being held via the MyFoundation portal: voters *must* use the
portal for the votes to be properly recorded.  The voting will continue
until either all 15 existing Committers have voted or until they have been
given enough time to vote, even if they do not do so (defined as at least
one week). Dennis Huebner must receive at least three +1s and no -1s for a
successful election.

Eligible Committers must cast their votes through their My Foundation
portal page (do NOT just reply to this email; your vote will not be
correctly recorded unless you use the portal):

The project Committers eligible to vote are:

    Nick Boldt
    =?UTF-8?Q?Andr=C3=A9?= Dietisheim
    Stephan Eberle
    Kenn Hussey
    Simon Mc Duff
    Ed Merks
    Marcelo Paternostro
    Victor Roldan Betancort
    Thomas Schindl
    Shaun Smith
    David Steinberg
    Eike Stepper
    Martin Taal
    Patrick Tessier
    Stefan Winkler

*NOTE*: Successful elections are left open for a maximum of 120 days to
allow for processing of paperwork.  After that time the election will be
expired, regardless of its current status.  Should papework processing on
the part of the candidate take more time than allowed, a new election will
have to be held.

If you have any questions, please do not hesitate to contact your project
lead, PMC member, or the EMO <emo@xxxxxxxxxxx>

Back to the top