Skip to main content

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [List Home]
RE: [cdt-dev] Change in default include paths



Sorry for the delayed response – was busy with some local stuff here.

The “default” built-in include paths are calculated using the “org.eclipse.cdt.make.core.ScannerConfigurationDiscoveryProfile” extension point.

A typical Scanner discovery profile usage is the following:

1.       A tool-chain specific scanner discovery profile is defined by contributing to the “org.eclipse.cdt.make.core.ScannerConfigurationDiscoveryProfile” extension point.

2.       The profile ID is associated with the tool-chain by specifying the profile id via the inputType#scannerConfigDiscoveryProfileId or the toolChain#scannerConfigDiscoveryProfileId attributes.

(see the build gnu tool-chain build fefinitions in the org.eclipse.cdt.managedbuilder.gnu.ui plug-in for the reference implementation)


When the project is being created/loadded the profile associated with the project/configuration tool-chain is queryied for the default includes/symbols information.


So you will need to perform the two above steps in order to provide the includes/symbols info specific for your tool-chain

If you do not want the builtin includes/symbols information to be calculated at all you could simly associate no profile with your tool-chain (i.e. ommit both of the above steps)





From: cdt-dev-bounces@xxxxxxxxxxx [mailto:cdt-dev-bounces@xxxxxxxxxxx] On Behalf Of Sheldon Dsouza
Sent: Tuesday, July 31, 2007 7:17 PM
To: CDT General developers list.
Subject: Re: [cdt-dev] Change in default include paths


No not yet i tried to replace existing include paths in the configuration with my own using the template mechanism, my include paths were added successfully but the defaults did not get replaced.


On 7/31/07, Torkild Ulvøy Resheim <turesheim@xxxxxxxxx> wrote:

Hi Sheldon,
On Friday 20 July 2007 10:16, Sheldon Dsouza wrote:
> Ho Doug,
>  as you mentioned the includes are obtained from gcc itself, we are using a
> different toolchain so where can i make the change for the scanner
> discovery feature to ask my version of gcc for the includes.
> Regards,
> Sheldon
Did you find a solution to this? I'm looking into the same issue and cannot
find anything useful in documentation or source.
Torkild Ulvøy Resheim
Senior Design Engineer
Atmel Norway AS
cdt-dev mailing list


Back to the top