How to get correct area for printing nattable? [message #1576481] |
Wed, 21 January 2015 10:39 |
Shafi Vijapurwala Messages: 13 Registered: November 2014 |
Junior Member |
|
|
I am trying to print my nattable using Tutorial example as reference. The problem is that the nattable gets printed in such a small area on paper that it is difficult to properly view it. For example, the entire nattable occupies 1/8th area of the paper.
I tried built in nattable.doCommand(new PrintCommand(...)) initially, and got the above mentioned issue. (I added the stated nattable configurations as per the tutorial example)
Then I tried printing by using LayerPainter. The underlying layer I am trying to print is a CompositeLayer. I added my custom layerpainter and made some changes, but the size of the printed nattable did not increase. Please help.
[Updated on: Wed, 21 January 2015 10:46] Report message to a moderator
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03727 seconds