|
Re: Setting Workspace location rule [message #1403927 is a reply to message #1403921] |
Mon, 28 July 2014 15:29 |
Ed Merks Messages: 33141 Registered: July 2009 |
Senior Member |
|
|
Johannes,
Comments below.
On 28/07/2014 5:10 PM, Johannes Dorn wrote:
> Another hour, another question by me :)
>
> I'm trying to make a setup where a custom workspace location rule is
> preselected. Ideally, the drop down choice wouldn't be shown at all.
I think (but haven't tested), that if you define a variable named
workspace.location, and set as you show below, that it would override
the induced variable and there be no need to apply the rule. I'm not
sure it would be saved properly in the user.setup, i.e., that you won't
end up with the expanded form and have all subsequent installations
share the same workspace...
>
> The workspace location rule would be
> ${installation.location/foo}
>
> so basically, one of the standard cases but with "foo" instead of "ws".
> How can this be done?
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
|
Powered by
FUDForum. Page generated in 0.03661 seconds