DataAssociation question [message #1388263] |
Thu, 26 June 2014 07:34 |
Cédric Casenove Messages: 22 Registered: December 2013 |
Junior Member |
|
|
Hi Bob,
I use the ModelUtil.setValue() method to set the target of a DataAssociation which already have a source set. I noted that after the call to ModelUtil.setValue(), the ItemDefinition of the source is forced to the one of the target.
Is it a BPMN2 requirement to have both the source and target of a DataAssociation to point to the same ItemDefinition ? If this is the case, how can we do a transformation between 2 different structures ?
I looked into the DataAssociationPropertiesAdapter, and the implementation of the setSourceRef() and setTargetRef() seems to be where the itemSubjectRef attribute of the source/target ItemAwareElement are forced.
Thanks,
Regards.
|
|
|
Powered by
FUDForum. Page generated in 0.04388 seconds