Can't step while remote debugging in latest Kepler [message #1278703] |
Thu, 27 March 2014 18:37 |
Warwick Burrows Messages: 132 Registered: July 2009 Location: Austin, TX |
Senior Member |
|
|
Hi,
I installed the latest release of Kepler and opened by existing workspace with it. All the other aspects of the Kepler release seem fine but when I run up the debugger and hit a break point I'm not able to "step in" to method calls using either the icon on the toolbar or using the shortcut key. Also when I "step over" with F6 or I have to then go and click on the executing line in the debug/stack trace window for it to take effect in the editor window. e.g. the step does occur but isn't reflected in the editor window. Is anyone else seeing this as I wasn't able to find anything in this forum.
As noted I'm on the latest Kepler standard build. Win 7 64-bit.
Thanks,
Warwick
[Updated on: Thu, 27 March 2014 18:39] Report message to a moderator
|
|
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03828 seconds