|
Re: How to generate a sequence diagram from an interaction? [message #1064592 is a reply to message #1064547] |
Thu, 20 June 2013 07:20 |
|
I was trying to do the same (but I didnt try the template). There are many elements in a sequence diagram that you have to add and connect.
I suggest you to draw with Papyrus a sequence diagram with two timelines and one message, and then delete the .di file, and examine the interaction in the .uml file, and finally, try to create again a sequence diagram starting from this uml file, because it should work with that considering that Papyrus itself created all the elements that consider necessary.
I did that and I realized that there were some elements that I didnt consider...I am not sure if this is your problem, but just in case I wanted to share this with you
bye!
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.04010 seconds