How to set a part to default trim toolbar when it minimize [message #986676] |
Wed, 21 November 2012 10:49 |
|
Hi all,
I'm try to create a RCP application using Compatibility layer in eclipse-juno.
I am reusing Debug view and project explore its work fine, but the problem is when i try to minimize Debug view its hide with damaging all the perspective layout and not able to maximize again. But when I try to minimize Project Explore its minimize properly and able to maximize again.
When i explore using Live-Editor i found there is only 2 trimbar top and Bottom however in eclipse its 4, top, bottom , left and right.
I don't know exactly why this is happening. But i think because in my application i don't have left and right trimbar.
If its right then how i can add trimbar so that debug view can normally minimize and maximize. Or how to set a trimbar for a view so that it will get place on that trimbar when it minimized.
Thanks
[Updated on: Wed, 21 November 2012 10:50] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.02954 seconds