How to find out why parts of the application model are not visible ? [message #985233] |
Thu, 15 November 2012 08:57 |
Eclipse User |
|
|
|
Hi all,
i'm trying to run an example out of a book. If I start the app from testing section in the product config, the base app window is shown, but I can't see the parts. I there a possibility to "debug" this stuff? No result, no error, ....
application model, product config and manifest is attached.
Thanks!
|
|
|
|
|
Re: How to find out why parts of the application model are not visible ? [message #985278 is a reply to message #985261] |
Thu, 15 November 2012 09:23 |
Eclipse User |
|
|
|
Hi Thomas,
"e4 question are better asked at the e4 forum." thanks for the hint.
So here you are only discussing eclispe 3.x RCP topics and e4 RCP topics are discussed here "Home » Eclipse Projects » Eclipse 4" ??
Fredy
Thomas Schindl wrote on Thu, 15 November 2012 10:09Make sure you checked to clear the workspace in your launch
configuration, else you'll get up with a restored state.
e4 question are better asked at the e4 forum.
Tom
Am 15.11.12 09:57, schrieb hauschel Mising name:
> Hi all,
> i'm trying to run an example out of a book. If I start the app from testing section in the product config, the base app window is shown, but I can't see the parts. I there a possibility to "debug" this stuff? No result, no error, ....
>
> application model, product config and manifest is attached.
>
> Thanks!
>
|
|
|
Re: How to find out why parts of the application model are not visible ? [message #985318 is a reply to message #985278] |
Thu, 15 November 2012 09:55 |
Thomas Schindl Messages: 6651 Registered: July 2009 |
Senior Member |
|
|
Yep
Tom
Am 15.11.12 10:23, schrieb fred hauschel:
> Hi Thomas,
> "e4 question are better asked at the e4 forum." thanks for the hint.
> So here you are only discussing eclispe 3.x RCP topics and e4 RCP topics
> are discussed here "Home » Eclipse Projects » Eclipse 4" ??
>
> Fredy
>
> Thomas Schindl wrote on Thu, 15 November 2012 10:09
>> Make sure you checked to clear the workspace in your launch
>> configuration, else you'll get up with a restored state.
>>
>> e4 question are better asked at the e4 forum.
>>
>> Tom
>>
>> Am 15.11.12 09:57, schrieb hauschel Mising name:
>> > Hi all,
>> > i'm trying to run an example out of a book. If I start the app from
>> testing section in the product config, the base app window is shown,
>> but I can't see the parts. I there a possibility to "debug" this
>> stuff? No result, no error, ....
>> > > application model, product config and manifest is attached.
>> > > Thanks!
>> >
>
|
|
|
|
Powered by
FUDForum. Page generated in 0.04042 seconds