Removing Parameters from a referenced Test Case with parameters already set in Test Suite [message #892322] |
Wed, 27 June 2012 17:40 |
Amanda Mitchell Messages: 7 Registered: May 2012 |
Junior Member |
|
|
I've run into an this issue twice now, and it has caused me spend a lot of time fixing all of my tests.
If I have a test case that I have reference in a Test Suite. I've already entered all of my parameters for this test case in the Test Suite.
However, then I realize I forgot a step. I add it to the referenced test case, and the new parameters need to be filled in, in my test Suite. So i do that.
After running my tests, I find this new aspect that I added is causing more issues than helping my test, so i removed it and its parameters from the referenced test case.
However, since I had already filled parameters for the ones I just removed, All parameters for this test case have been jumbled around and no longer make any sense. For instance, values and entered for operators and operators for values ect, and nothing in the correct place. So I have to go through and re-enter all of my parameters every place this test case is present in any of my test suites.
I could understand this issue, if the parameters i removed were in the middle of my list, but they were at the end and should not have affected any of my other parameters.
I just wanted to let people know, don't do this otherwise you'll spend a significant amount of time re-entering parameters.
|
|
|
|
Powered by
FUDForum. Page generated in 0.02878 seconds