|
Re: library with joint data set not setting parameter [message #892585 is a reply to message #892294] |
Thu, 28 June 2012 15:38 |
|
I seem to remember there was an issue with this with earlier versions.
What version are you using?
Jason
On 6/27/2012 12:05 PM, mike b wrote:
> I am having an issue where the parameter in a joint data set within a
> library is not being set from the outer table.
>
> I have 2 tables one nested inside of the first. The first table is
> bound to a dataset with an id column and the nested table is bound to a
> joint data set. I bound the 1 parameter to the id of the first table,
> but it always uses the default value.
>
> If I move the tables/data sets to a blank report it correctly sets the
> parameter value in the nested table.
>
> Is this a known issue? If so is there a workaround for it?
>
> Thank you
>
|
|
|
Re: library with joint data set not setting parameter [message #892589 is a reply to message #892294] |
Thu, 28 June 2012 15:38 |
|
I seem to remember there was an issue with this with earlier versions.
What version are you using?
Jason
On 6/27/2012 12:05 PM, mike b wrote:
> I am having an issue where the parameter in a joint data set within a
> library is not being set from the outer table.
>
> I have 2 tables one nested inside of the first. The first table is
> bound to a dataset with an id column and the nested table is bound to a
> joint data set. I bound the 1 parameter to the id of the first table,
> but it always uses the default value.
>
> If I move the tables/data sets to a blank report it correctly sets the
> parameter value in the nested table.
>
> Is this a known issue? If so is there a workaround for it?
>
> Thank you
>
|
|
|
|
|
Powered by
FUDForum. Page generated in 0.03441 seconds