Repopulating a table in the dialog on checkbox selection [message #629957] |
Thu, 30 September 2010 06:45 |
Animesh Kumar Messages: 18 Registered: September 2010 Location: Bangalore |
Junior Member |
|
|
Hi,
I was trying to create a search dialog which searches all the .xml files and .project files and shows the result in a table viewer in the dialog. I have added two check boxes for filtering the results. One is for .project files and other for .xml files. How can I repopulate the table and thus the dialog without searching for the files again. I just wanted a filtering of already done search which retrieved all .project and .xml files in the workspace.
Can somebody help me with it. I want a simple example.
I have seen the code for the Dialog for adding Extension Points in the Manifest.MF but could not understand how that can be used in my case.
Regards,
Animesh
|
|
|
|
Powered by
FUDForum. Page generated in 0.13914 seconds