part's multiplicity [message #626172] |
Tue, 11 March 2008 06:58 |
charfi asma Messages: 78 Registered: July 2009 |
Member |
|
|
Hi
- the default value of multiplicity in attribute is [0..*] according to the
spec page 14 "Each
attribute is specified by its formal name, its type, and multiplicity. If no
multiplicity is listed, it defaults to 0..*"
-the default value of multiplicity in attribute is 1 according to the spec
page 21 "If no multiplicity is shown on an association end, it implies a
multiplicity of exactly 1."
- what is the default value of multiplicity in a part (instance of
component). (when we instnaciate a component that contain a part, if we
don't specify the multiplicity of the part, it wil be 1 or [0..1]?
what is also the default value of multiplicity in Port?
thank you a lot
Asma
|
|
|
Powered by
FUDForum. Page generated in 0.02624 seconds