|
|
|
Re: Subsets and redefines code generation problem [message #553450 is a reply to message #549580] |
Tue, 17 August 2010 14:48 |
Ed Merks Messages: 33217 Registered: July 2009 |
Senior Member |
|
|
Chokri,
Packages without classifiers aren't generated and normally aren't
needed. You could try to add a dummy classifier to any package that's
not generated...
Chokri Mraidha wrote:
> Hello,
>
> I am specifying a hierachical static profile containing subsetted and
> redefined properties. The transformation to ecore runs well and takes into
> account subsets and redefines. However, the generated code does not compile.
> The top level profile package is not generated but is used in subprofiles
> containing subsetted or redefined properties.
> Please find enclosed a small example illustrating the problem.
>
> Chokri
>
>
>
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
|
|
Re: Subsets and redefines code generation problem [message #628595 is a reply to message #549580] |
Tue, 17 August 2010 14:48 |
Ed Merks Messages: 33217 Registered: July 2009 |
Senior Member |
|
|
Chokri,
Packages without classifiers aren't generated and normally aren't
needed. You could try to add a dummy classifier to any package that's
not generated...
Chokri Mraidha wrote:
> Hello,
>
> I am specifying a hierachical static profile containing subsetted and
> redefined properties. The transformation to ecore runs well and takes into
> account subsets and redefines. However, the generated code does not compile.
> The top level profile package is not generated but is used in subprofiles
> containing subsetted or redefined properties.
> Please find enclosed a small example illustrating the problem.
>
> Chokri
>
>
>
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.03474 seconds