Eclipse Community Forums: Buckminster » headless buckminster and silent fail

Help

Home

Home » Archived » Buckminster » headless buckminster and silent fail

Show: Today's Messages :: Show Polls :: Message Navigator

headless buckminster and silent fail [message #516281]

Tue, 23 February 2010 13:41

Bernhard Merkle

Messages: 88
Registered: July 2009

Member

Hi again,

during setup my headless buckminster i stumbled over a "feature".

I forgot to install the command for headless PDE build.
However if I invoke buckminster clean or buckminster build I get NO warning/that there is no target in my workspace.

Only after installing the PDE build command in bucky headless the build/clean worked as expected.

IMO it would be nice if bucky shouts out: no target found or something like that. Failing silently is unconvenient in most cases.

Should I open a bugzilla for that ? (if you consider this a usefull behaviour ?)

thanks,
Bernhard.

Report message to a moderator

Re: headless buckminster and silent fail [message #516306 is a reply to message #516281]

Tue, 23 February 2010 15:02

Henrik Lindberg

Messages: 2509
Registered: July 2009

Senior Member

I guess the question is, how buckminster could even know that it was
supposed to do something with PDE when it has no support for PDE
installed :)

It would be nice to get a warning like:
Workspace contains projects of natures/types for which support has not
been installed...

Having a configuration where everything in the workspace is not being
built is valid, so I think it should be a warning and not a hard error.

Please file an enhancement request in bugzilla.

Regards
- henrik

On 2/23/10 2:41 PM, Bernhard Merkle wrote:
> Hi again,
>
> during setup my headless buckminster i stumbled over a "feature".
>
> I forgot to install the command for headless PDE build.
> However if I invoke buckminster clean or buckminster build I get NO
> warning/that there is no target in my workspace.
>
> Only after installing the PDE build command in bucky headless the
> build/clean worked as expected.
>
> IMO it would be nice if bucky shouts out: no target found or something
> like that. Failing silently is unconvenient in most cases.
>
> Should I open a bugzilla for that ? (if you consider this a usefull
> behaviour ?)
>
> thanks,
> Bernhard.
>

Report message to a moderator

Previous Topic:	Custom zip filename in CSPECX
Next Topic:	junit command fails with 'Process {0} terminated with exit status {1}' for 'Junit Plug-in Test'

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Fri Apr 26 03:09:11 GMT 2024

.:: Contact :: Home ::.

Breadcrumbs

Sign up to our Newsletter