|
|
Re: How to mark Nodes [message #516211 is a reply to message #515880] |
Tue, 23 February 2010 08:51 |
Dennis sui Messages: 35 Registered: February 2010 |
Member |
|
|
Hi,
thanks for your reply but i'd would like to do this without this tools.
At the moment, i have a BatchValidator File like in the EMF Validation Framework Example.
In this File, i start the ValidateAction.run() Method which creates Markers an Decoraters from the Diagnostion.
Later i try the same way of creating Decoraters as in the ValidateAction. this should work.
My question now is:
what is the difference between EMF Validation Framework an the Diagnostics Validation?
When i start the ValidateAction.run (programmly or per Edit->validate) this woks well. It also checks the OCL constraints which i did in the GmfMap File.
Now, what is the clue of EMF Validation Framework?
Do I need it ?
I am a little confused.
[Updated on: Tue, 23 February 2010 10:14] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.06238 seconds