[Sirius] Need to reopen the diagram after layout [message #1794339] |
Wed, 29 August 2018 08:38 |
lee lucky Messages: 26 Registered: October 2017 |
Junior Member |
|
|
Hi,
Recently, I am using ELK to layout my model diagram in Sirius editor. I found a problem, the steps for reproduction is that:
1). Execute my ELK layout in Sirius editor, it works well.
2). Hide some connectors(edges) and ports(bordered nodes).
3). Relayout on this diagram, it works well, too.
4). Show these hidden elements.
5). Execute ELK layout on this diagram again.
The result in step 5) is messed-up, it looks like these ports which are shown after hidden are not placed in their places. But, when I close this diagram, and then reopen it, the diagram is shown well as the step 1) shows.
I searched this problem, I found that website:
https://bugs.eclipse.org/bugs/show_bug.cgi?id=291484
My problem looks like this problem, it seems that it is a bug of GMF. Would you give me some suggestions to fix my problem in Sirius editor?
Thanks in advance and hope for your reply.
|
|
|
|
Powered by
FUDForum. Page generated in 0.03504 seconds