All layers are equal (or not?) [message #1790858] |
Tue, 19 June 2018 07:29 |
Wilbert Alberts Messages: 210 Registered: June 2010 |
Senior Member |
|
|
Hi,
My user noticed that the visibility of some of my layers wasn't persisted with the diagram. Furthermore, he noticed that the layers, whose visibility state was not persisted, were grouped below a separator line.
I noticed that these layers don't have any visualizations. They only contain decorations and some tools.
Is this intentional or did I trigger a bug?
I attached a (somewhat obfuscated) image of the layers menu. The lowest two layers are separated from the others as described above.
Greetings,
Wilbert.
-
Attachment: layers.png
(Size: 13.96KB, Downloaded 53 times)
[Updated on: Tue, 19 June 2018 07:29] Report message to a moderator
|
|
|
|
Re: All layers are equal (or not?) [message #1790951 is a reply to message #1790922] |
Wed, 20 June 2018 13:46 |
|
Hello
A layer is considered as transient if it contains only tools or decoration. If you want to persist the layer activation you may, as a workaround, add a fake node mapping without id.
We aim to add an attribute on the layer to know if it is layer or not, but I have no target release to give you at this time.
Regards
Laurent
Laurent Fasani - Obeo
Need training or professional services for Sirius?
http://www.obeodesigner.com/sirius
|
|
|
Powered by
FUDForum. Page generated in 0.04602 seconds