|
Re: Empty variables wizard page [message #1786417 is a reply to message #1786401] |
Thu, 03 May 2018 05:27 |
Ed Merks Messages: 33218 Registered: July 2009 |
Senior Member |
|
|
You almost answered the question yourself with regard to what "Show All Variables" does. I.e., if a variable already has a value, specifically a value that comes from the context, i.e., from the user.setup, workspace.setup, or installation.setup, then the user does not need to enter its value. So if the project stream does not itself contain any variable without a value, or that variable is already assigned a value in the context, the user does not need to enter anything (i.e., has no decisions to make) in order to proceed.
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.02740 seconds