Skip to main content


Eclipse Community Forums

      Home
Home » Modeling » EMF » the diagram components messy when opened in editor(nodes and edges copied in new file but breaking when openend in editor)
the diagram components messy when opened in editor [message #1759901] Wed, 19 April 2017 12:52 Go to next message
Eclipse UserFriend
Hello,

has anyone any idea that why the GMF diagram in editor breaks? I have copied the EMF nodes and edges into a new Model File and all the contents are shown in the XMI file also as correctly. But at the time of opening the same .henshin_diagram file in GMF editor, the components i.e. Nodes and Edges are all Messy and not in right order...

Has anyone any idea why is it so?
Re: the diagram components messy when opened in editor [message #1759902 is a reply to message #1759901] Wed, 19 April 2017 13:30 Go to previous messageGo to next message
Eclipse UserFriend
It's better to ask about GMF on the GMF forum.
Re: the diagram components messy when opened in editor [message #1759905 is a reply to message #1759902] Wed, 19 April 2017 14:04 Go to previous message
Eclipse UserFriend
I have tried there but no one answers usually, I will try again Smile thanks...
Previous Topic:Resourceset Change Location at Runtime but not updated while saving
Next Topic:[Teneo] Mapping a combined primary key with teneo
Goto Forum:
  


Current Time: Sat Nov 08 12:17:07 EST 2025

Powered by FUDForum. Page generated in 0.24203 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top

Sign up to our Newsletter

A fresh new issue delivered monthly