|
Re: Does Titan support "address" in port? [message #1750195 is a reply to message #1750193] |
Sat, 17 December 2016 09:38 |
|
Hi Carson,
this usage of address is not supported currently;
I believe it is safe to assume that if you use Titan you will also use Titan test ports and these will not need the above usage.
There is a special usage of address which is declared as an extension to a test port declaration:
with {extension "address"}
but this is only used and needed if I remember correctly only for the SIPmsg test port
https://github.com/eclipse/titan.TestPorts.SIPmsg
else you should not need to assign an address.
For details , see referenceguide 3.7 Address Type
and API guide 2.4 Support of address type
Similarly, map param and unmap param are not supported either:
test port parameters are assigned via the configuration file
and in some cases (where the port supports it) can be changed dynamically from the TTCN-3 code by sending appropriate configuration messages; but this differs from port to port.
I hope this helps
Best regards
Elemer
|
|
|
Powered by
FUDForum. Page generated in 0.03038 seconds