Release runs immediately after Debug [message #1747266] |
Fri, 11 November 2016 12:53 |
Jack Wilborn Messages: 8 Registered: February 2016 |
Junior Member |
|
|
Hello, I have modified something in Eclipse that when 'build' is clicked, it does the build properly under Debug (as far as I can tell, as it's very fast.) Then it does a release build which 'cleans' all of the information created by the initial build.
I have checked the configuration and I'm in "Debug" not "Release".
I know before I attempted to create a library, it was working ok. Don't know if that's exactly the cause, but it's as close as I can come as to when this problem was created.
This has been a problem for a few weeks now and I need to get it back up, hopefully without a re-install..
I hate to backup, reinstall when it's probably just a switch somewhere that is clicked.
Thanks for any suggestions.
Jack
Never found the problem, ended up backing up source and re-install of Eclipse. It would have been nice to know what I did...
[Updated on: Sun, 13 November 2016 00:47] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.02677 seconds