|
|
|
|
Re: Ecore model support for .net [message #1739275 is a reply to message #1739261] |
Fri, 29 July 2016 09:01 |
naveen ramesh Messages: 56 Registered: May 2016 |
Member |
|
|
Ok we understand it.But I have defined the ecore model and generated the plugins for my model and written some additional plugins to it.So we want the same design to be ported to C#. Is this can be done.Because my plugins are internally related to EMF plugins so if I try to bring my plugins to C# we should also bring EMF plugins which internally will be related to some other Eclipse plugins.So can this design be portable to other platform or it is built only for eclipse and not for other platform?
If no why can't it be possible.
Please provide the solution for this
[Updated on: Fri, 29 July 2016 09:05] Report message to a moderator
|
|
|
|
|
Re: Ecore model support for .net [message #1739502 is a reply to message #1739409] |
Mon, 01 August 2016 07:43 |
Ed Willink Messages: 7670 Registered: July 2009 |
Senior Member |
|
|
Hi Jonas
It depends what you mean by "support".
If you just want a C# representation of the model then that is a
straightforward model-to-text problem that can be dealt with by
Acceleo/JET/Xtend or direct code.
If you want the full EMF run-time support for platform:, eInvoke,
eSettingDelegate, ExtendedMetaData, ... then that is a very major
undertaking. Mindless Java to C# migration might do most of it, but the
subtleties of classpaths, reflection, generics and boxing are sure to
give some excitements. (If someone really wants to do this a dilemma
will no doubt arise as to whether a more compatible EMF 3.x architecture
might evolve to exploit the experience of the last ten years.)
The author seemed to want the IDE to be ported to C# as well ....
Regards
Ed Willink
On 01/08/2016 07:10, Jonas Helming wrote:
> Hi,
>
> I do not think there is any conceptional reason, that C# could not be
> supported by EMF, it just seems to not be available at the moment. So
> you can either implement that yourself or sponsor the development.
>
> Best regards
> Jonas
>
>
> On 29.07.2016 11:01, naveen ramesh wrote:
>> Ok i understand it.But i have defined the ecore model and generated the
>> plugins for my model and written some additional plugins to it.So i want
>> the same design to be ported to C#.Is this can be done.
>> If no can we get the valid reason
>
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
|
|
|
Powered by
FUDForum. Page generated in 0.04162 seconds