|
|
Re: Configure perspective with Oomph [message #1738898 is a reply to message #1738882] |
Mon, 25 July 2016 19:38 |
|
Hi, Ed,
Isn't there an Eclipse Launcher command-line option that can set the
initial perspective, which Oomph can add to the eclipse.ini using an
"Eclipse Ini" task?
-perspective your.perspective.id.here
cW
On 2016-07-25 16:44:58 +0000, Ed Merks said:
> Harald,
>
> No, we have some prototype work for that, but nothing you can use today.
>
>
> On 25.07.2016 18:18, Harald Brunner wrote:
>> Hi,
>>
>> is there a way to configure a perspective within an Oomph setup file?
>> E.g. change the default Plug-In Development perspective, or add a
>> custom perspective.
>>
>> Thanks,
>> Harald
|
|
|
Re: Configure perspective with Oomph [message #1738900 is a reply to message #1738898] |
Mon, 25 July 2016 20:01 |
Ed Merks Messages: 33142 Registered: July 2009 |
Senior Member |
|
|
Christian,
Yes, but that doesn't let you configure an existing perspective. You'd
need to install something that contributes a new per-configured
perspective. Ideally it would be much easier to do than installing
something that contributes to extension points...
On 25.07.2016 21:38, Christian W. Damus wrote:
> Hi, Ed,
>
> Isn't there an Eclipse Launcher command-line option that can set the
> initial perspective, which Oomph can add to the eclipse.ini using an
> "Eclipse Ini" task?
>
> -perspective your.perspective.id.here
>
> cW
>
>
> On 2016-07-25 16:44:58 +0000, Ed Merks said:
>
>> Harald,
>>
>> No, we have some prototype work for that, but nothing you can use today.
>>
>>
>> On 25.07.2016 18:18, Harald Brunner wrote:
>>> Hi,
>>>
>>> is there a way to configure a perspective within an Oomph setup file?
>>> E.g. change the default Plug-In Development perspective, or add a
>>> custom perspective.
>>>
>>> Thanks,
>>> Harald
>
>
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.04853 seconds