Incompatible JVM [message #1703529] |
Sun, 02 August 2015 15:23 |
Richard Hausman Messages: 1 Registered: August 2015 |
Junior Member |
|
|
Firstly, thank you in advance for any and all help. I am a complete newcomer!
So, I installed eclipse. Then, I installed java 8. Then, I tried to open eclipse. Following message appears: "Version 1.6.0_65 of the JVM is not suitable for this product. Version: 1.6 or greater is required.". So, after visiting this forum, I read about Eclipse.ini, in order to "specify a java virtual machine" as recomended. However, Eclipse.ini was meaningless to me because it was too complex. I couldn't understand it. Please, I want only to open Eclipse. I do not understand why this is so difficult. When I installed the Arduino IDE, for example, I just clicked download and began writing code.
Help would be greatly appreciated. I am a beginner, so please keep you language simple!
Many thanks,
Richard Hausman.
|
|
|
Re: Incompatible JVM [message #1703536 is a reply to message #1703529] |
Sun, 02 August 2015 20:31 |
Ed Merks Messages: 33142 Registered: July 2009 |
Senior Member |
|
|
Richard,
Maybe try the new installer:
http://www.eclipse.org/downloads/installer.php
It will detect all your JVMs and use one that will work, or tell you
which one you need if none of them will work.
On 02/08/2015 9:10 PM, Richard Hausman wrote:
> Firstly, thank you in advance for any and all help. I am a complete
> newcomer!
> So, I installed eclipse. Then, I installed java 8. Then, I tried to
> open eclipse. Following message appears: "Version 1.6.0_65 of the JVM
> is not suitable for this product. Version: 1.6 or greater is
> required.". So, after visiting this forum, I read about Eclipse.ini,
> in order to "specify a java virtual machine" as recomended. However,
> Eclipse.ini was meaningless to me because it was too complex. I
> couldn't understand it. Please, I want only to open Eclipse. I do not
> understand why this is so difficult. When I installed the Arduino IDE,
> for example, I just clicked download and began writing code.
> Help would be greatly appreciated. I am a beginner, so please keep you
> language simple! Many thanks,
> Richard Hausman.
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
|
Powered by
FUDForum. Page generated in 0.08434 seconds