Boader of workspace image [message #1625003] |
Fri, 20 February 2015 04:58 |
Xue Liu Messages: 21 Registered: May 2014 |
Junior Member |
|
|
Hi,
I drawed a vector rectangle figure as the worksapce image for a "Container". Since the length-width ratio of this rectangle is fix, in order to make the boarder automatically fit the rectangle, I set the "size computation expression" to "-1". But it does not work properply. I also apply different rectangle figures for "Node". They work fine. My question is how to configure the properties of workspace image to meet my requirement.
Regards,
Xue Liu
-
Attachment: dfdp.zip
(Size: 982.83KB, Downloaded 103 times)
[Updated on: Fri, 20 February 2015 04:59] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.02919 seconds