| Cannot Move Bendpoints [message #211876] |
Mon, 24 November 2008 06:20 |
Eclipse User |
|
|
|
Hello All,
Bendpoints in a rectilinear router, are allowed to move only on horizontal
or vertical directions.
I have a BorderitemRectilinear router (modified rectilinear router), but
strangely there are certain bendpoints that cannot be moved in either
direction. It behaves as if the horizontal and vertical movements have
overlapped on top of each other, and simply remains in that location. The
pattern is not constant, but mostly it takes place where a horizontal line
bends vertically up or down.
As a result, that section of connection also doesn't move.
Anyone has a solution? Is there any property of bendpoints that I can play
around?
~Sandip
|
|
|
Powered by
FUDForum. Page generated in 0.02391 seconds
Home