Skip to main content



      Home
Home » Modeling » Papyrus » Change node type on an activity diagram
Change node type on an activity diagram [message #1405900] Fri, 08 August 2014 08:40 Go to next message
Eclipse UserFriend
Is it possible to change a node type on an activity diagram.

I created an action but then realized it should be a send signal action. The only way I could figure out how to change it is to delete and replace it, redrawing all of the connections in the process.
Re: Change node type on an activity diagram [message #1405902 is a reply to message #1405900] Fri, 08 August 2014 08:44 Go to previous message
Eclipse UserFriend
Hi,

This is currently not supported in Papyrus. There is a work-in-progress component to allow such refactorings, but it is currently not available

Regards,
Camille
Previous Topic:Activity Diagram: Precondition compartment not showing constraint.
Next Topic:InstanceSpecification element on Composite diagram
Goto Forum:
  


Current Time: Wed Jul 02 14:46:34 EDT 2025

Powered by FUDForum. Page generated in 0.26210 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top