Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » BPMN 2.0 Modeler » Exclusive Gateway Direction - 2/4 supported?
Exclusive Gateway Direction - 2/4 supported? [message #1385436] Fri, 06 June 2014 12:37 Go to next message
Krassimir Kondarev is currently offline Krassimir KondarevFriend
Messages: 32
Registered: July 2009
Member
Hi,

is these a concrete reason for the limited Gateway Directions support for Exclusive Gateways?

It seems that two from the four Directions are supported - Converging and Diverging. For the "Mixed" I get the message "Invalid Gateway direction for Exclusive Gateway. It should be "Converging" or "Diverging"". For "Unspecified" (which should be a supported value) I get: "Exclusive Gateway has missing or incomplete Gateway Direction".

BPMN2 modeler version: 1.0.1

Best regards,
Krassimir
Re: Exclusive Gateway Direction - 2/4 supported? [message #1385471 is a reply to message #1385436] Fri, 06 June 2014 15:54 Go to previous messageGo to next message
Robert Brodt is currently offline Robert BrodtFriend
Messages: 692
Registered: August 2010
Location: Colorado Springs, CO
Senior Member

Hi Krassimir,

Yes, you are correct - this validation constraint needs further investigation. Can you please file a bugzilla so we don't forget about this for a future release?

Thanks!
Bob

P.S. After re-reading section 10.5.1 of the BPMN 2.0 spec, it occurred to me that the editor should probably set the Gateway Direction bit based on the number of incoming & outgoing connections. Can you please add that suggestion to the bugzilla?

[Updated on: Fri, 06 June 2014 15:57]

Report message to a moderator

Re: Exclusive Gateway Direction - 2/4 supported? [message #1385663 is a reply to message #1385471] Tue, 10 June 2014 10:47 Go to previous message
Krassimir Kondarev is currently offline Krassimir KondarevFriend
Messages: 32
Registered: July 2009
Member
Hi Bob,

done: https://bugs.eclipse.org/bugs/show_bug.cgi?id=437038

Thanks and regards,
Krassimir
Previous Topic:Impossible to create a SequenceFlow if the target is a Catch Event
Next Topic:Wiki updated
Goto Forum:
  


Current Time: Fri May 22 22:21:00 GMT 2015

Powered by FUDForum. Page generated in 0.05237 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software