Overlapping connections [message #230083] |
Wed, 13 May 2009 13:20 |
Sandip Messages: 39 Registered: July 2009 |
Member |
|
|
Hi,
In my diagram, I have connections between multiple rectangles(components)
having ports(borderitems).
I am using a BorderItemRectilinear Router for routing connections between
ports.
However, I observed that connections originating from the same rectangle,
going in the same direction often overlaps one on top of another. They
bunch up and look like a single line, which again separates as these
connections reach their respective targets. Seems like all these are
taking similar bend points for some distance.
Is there some way I can stop connections to overlap on top of each other
by default, when going in the same direction? They should appear at
distance from each other. Do I have to manually play with the bend points,
after these connections are created?
~Sandip
|
|
|
Powered by
FUDForum. Page generated in 0.03067 seconds