Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Modeling » GMF (Graphical Modeling Framework) » Figure Resize only bigger
Figure Resize only bigger [message #206145] Sun, 21 September 2008 10:13 Go to next message
Michael is currently offline MichaelFriend
Messages: 23
Registered: July 2009
Junior Member
Hi,

I added a stickman actor figure to my diagram, like in the UML2 project.
But resize of the container rectangle only works in one way, I can make
it bigger but not smaller. Could it be, that the included figure is not
notified when the container rectangle shrinks?

Thanks a lot,
Michael
Re: Figure Resize only bigger [message #206153 is a reply to message #206145] Sun, 21 September 2008 10:16 Go to previous message
Michael is currently offline MichaelFriend
Messages: 23
Registered: July 2009
Junior Member
Michael Dengler wrote:
> Hi,
>
> I added a stickman actor figure to my diagram, like in the UML2 project.
> But resize of the container rectangle only works in one way, I can make
> it bigger but not smaller. Could it be, that the included figure is not
> notified when the container rectangle shrinks?
>
> Thanks a lot,
> Michael

I have to note, that the stickman actor in the UML2 project shows the
same behavior.
Previous Topic:EMF/GMF constraints - help
Next Topic:Single connection between two nodes
Goto Forum:
  


Current Time: Thu May 13 16:18:38 GMT 2021

Powered by FUDForum. Page generated in 0.01808 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top