| Connection pointing back to the same figure [message #182525] |
Wed, 25 May 2005 18:27  |
Eclipse User |
|
|
|
Originally posted by: eri_cao_apex.yahoo.com
Hi,
The situation is that a connection starts from a figure will point back to
the same figure. That means the start point and end point will be on the
same figure. I tried all available connection routers, it seems that they
cannot handle that automatically. Anyone has seen this type of connection
before? If I can make it work by subclassing one of connection router
classes, what would be a good start point? I guess I need to find out how
the connection figure out endpoint.
Thanks a lot,
Eric
|
|
|
| Re: Connection pointing back to the same figure [message #182654 is a reply to message #182525] |
Wed, 25 May 2005 20:17  |
| Eclipse User |
|
|
|
Your router can detect this case (when the start and end are the same
location) and introduce some points in the connection if there are none.
"Eric Cao" <eri_cao_apex@yahoo.com> wrote in message
news:d72ub5$5uf$1@news.eclipse.org...
> Hi,
>
> The situation is that a connection starts from a figure will point back to
> the same figure. That means the start point and end point will be on the
> same figure. I tried all available connection routers, it seems that they
> cannot handle that automatically. Anyone has seen this type of connection
> before? If I can make it work by subclassing one of connection router
> classes, what would be a good start point? I guess I need to find out how
> the connection figure out endpoint.
>
> Thanks a lot,
>
> Eric
>
>
|
|
|
Powered by
FUDForum. Page generated in 0.02472 seconds
Home