|Re: When should a task appear in the Synchonize view? [message #19394 is a reply to message #14276]
||Thu, 26 July 2007 05:54
Originally posted by: beatmik.acm.org|
Dave Syer wrote:
> I do have the Mylyn Bridge component mentioned.
> I did not find the FAQ very helpful - it talked about "models mode" which is
> a new concept for me and I can't see the switch mentioned in the article to
> toggle it (possibly because it is CVS-specific and I am using SVN, but I
> wasn't able to tell from reading the FAQ?).
The documentation is for the Mylyn-distributed integration only (i.e.
CVS). I added the following clarifications for Subclipse.
Note that not all tools may support both modes. The instructions below
are for the CVS support included with Mylyn. Refer to the Mylyn
integration documentation for your source control plug-in for additional
instructions for Mylyn change set integration, if available.
* Subclipse users: note that Subclipse 1.2.3 and later functions as if
in the models mode described below, so the additional configuration step
is not needed.
Powered by FUDForum
. Page generated in 0.02365 seconds