|Re: returning single pieces of data in an oda [message #905080 is a reply to message #905079]
||Wed, 29 August 2012 16:35
| Jason Weathersby
Registered: July 2009
BTW if you think this will be to difficult for your users to find, I |
would just add it as a column.
On 8/29/2012 12:35 PM, Jason Weathersby wrote:
> Output parameters do show up in the data set editor, but that does not
> mean that they can be set. When they show up users can reference them
> in a bound table by calling outputParams["myoutputparameter"]. If you
> want to implement one you need to implement the getParameterMetaData()
> method in the class that implements the IQuery. Also return true in
> your class that implements IDataSetMetaData for the the
> supportsOutParameters method.
> On 8/29/2012 11:48 AM, James Whitehead wrote:
>> It does stay the same, I thought about setting up an output parameter,
>> but couldn't figure out where in the oda would be set? The only place
>> parameters seem to be called is in the UI customDataSetWizardPage, which
>> isn't ideal.
>> Thanks for your help,
Powered by FUDForum
. Page generated in 0.01710 seconds