Skip to main content



      Home
Home » Archived » BIRT » what is the meaning of "can shrink" for table element?
what is the meaning of "can shrink" for table element? [message #714710] Thu, 11 August 2011 06:28 Go to next message
Eclipse UserFriend
I found the table element has a checkbox called "can shrink", what is its usage?

my birt designer version is 2.2.1
(no subject) [message #714875 is a reply to message #714710] Thu, 11 August 2011 11:57 Go to previous messageGo to next message
Eclipse UserFriend
This setting if checked will shrink a container to its contents. This
will only work if you do not specify a height or width values for the
container. Run the attached report then select the canshrink checkbox
for the grid and run it again. BTW the report was done in BIRT 2.6.1.

Jason

On 8/11/2011 6:28 AM, tong123123 wrote:
> I found the table element has a checkbox called "can shrink", what is
> its usage?
>
> my birt designer version is 2.2.1
>
Re: (no subject) [message #989753 is a reply to message #714875] Fri, 07 December 2012 10:07 Go to previous message
Eclipse UserFriend
Does it works also in PDF output? When I view the attached report as HTML, it works perfectly. But if I run it as PDF shrink it's ignored.
Previous Topic:[BIRT 2.5.2] Crosstab - Dynamic columns width autofit issues
Next Topic:How to justify the table to center in a BIRT Report
Goto Forum:
  


Current Time: Sat Jul 12 21:43:50 EDT 2025

Powered by FUDForum. Page generated in 0.02962 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top