CoIARPlugin now supports LM3Sxx&LPC1763 and Amontec JTAGKey [message #697774] |
Mon, 18 July 2011 01:53 |
nicole_coocox Messages: 13 Registered: April 2011 |
Junior Member |
|
|
After the release of the intelligent pin configuration and code generation tool CoSmart V1.0, CooCox released CoIARPlugin V1.2.2 on July 15th.
The new version adds the support for not only TI LM3Sxx series chips and NXP LPC1763, but also FTDI debugger Amontec JTAGKey. Until now, CoIARPlugin has supported CooCox Colink, CoLinkEx, NGX, PicoJTAG, KT-Link, Amontec JTAGKey, Olimex-Open OCD, Stellaris-ICDI, and Nu-link.
What's more, the bug that when using under win7, the configuration of RDI settings cannot be modified if you don't run IAR as administrator account has been corrected.
For more details, please visit http://www.coocox.org/CoLinkGuide/CoIARPlugin_Updates.htm
Some user's need, "Can I use nxp lpcexpresso board with coocox as emulator?"http://www.coocox.org/Forum/topic.php?id=582 It's not the first time this issue was put forward, maybe it's necessary for NXP to consider developing interfaces.
Any question or advice? please go to the forum.
To know more about CooCox, please visit http://www.coocox.org/
[Updated on: Mon, 18 July 2011 02:41] Report message to a moderator
|
|
|
Powered by
FUDForum. Page generated in 0.03041 seconds