Skip to main content


Eclipse Community Forums
Forum Search:

Search      Help    Register    Login    Home
Home » Eclipse Projects » Eclipse Platform » Repopulating a table in the dialog on checkbox selection(How to repopulate a table in the dialog)
Repopulating a table in the dialog on checkbox selection [message #629959] Thu, 30 September 2010 06:48 Go to next message
Animesh Kumar is currently offline Animesh KumarFriend
Messages: 18
Registered: September 2010
Location: Bangalore
Junior Member
Hi,
I was trying to create a search dialog which searches all the .xml files and .project files and shows the result in a table viewer in the dialog. I have added two check boxes for filtering the results. One is for .project files and other for .xml files. How can I repopulate the table and thus the dialog without searching for the files again. I just wanted a filtering of already done search which retrieved all .project and .xml files in the workspace.
Can somebody help me with it. I want a simple example.
I have seen the code for the Dialog for adding Extension Points in the Manifest.MF but could not understand how that can be used in my case.


Regards,
Animesh
Re: Repopulating a table in the dialog on checkbox selection [message #630017 is a reply to message #629959] Thu, 30 September 2010 12:03 Go to previous message
Animesh Kumar is currently offline Animesh KumarFriend
Messages: 18
Registered: September 2010
Location: Bangalore
Junior Member
I got it... It was much simpler than i had expected Smile

Regards,
Animesh
Previous Topic:Shortcut key not appearing
Next Topic:Multi Editor
Goto Forum:
  


Current Time: Fri Jan 22 03:32:28 GMT 2021

Powered by FUDForum. Page generated in 0.02088 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top