|
|
Re: RAP-EMF integration trouble [message #622525 is a reply to message #622523] |
Thu, 29 April 2010 15:46 |
Ed Merks Messages: 33142 Registered: July 2009 |
Senior Member |
|
|
Aditya,
You should use the EMF newsgroup/forum.
More comments below.
Aditya Gupta wrote:
> Hi,
>
> I dont know if this is the right place to post questions about RAP,
> but since i couldnt find any other suitable link i posted it here.
>
> I went through eclipse wiki article for RAP- EMF integration, but it
> was a little confusing. First it said that i need EMF 2.6 and RAP
> Tooling 1.3 to do the integration, but just a few line below it said
> that the plugins shouldn't be installed in the IDE as it could break it.
Yes, they need to be in the target platform against which you develop
your plugins, not installed in the IDE.
>
> So I tried putting the EMF 2.6 files in the RAPTarget folder that i
> had created earlier to configure a Target Platform for running RAP
> applications. It didn't work.
Only the RAP plugins would go there.
>
> Can any one please guide me how to use RAP esp. RAP-EMF integration.
> It looks wonderful as a concept, but I am struggling to leverage it.
Hopefully Kenn can provide a few more details.
>
> Regards,
> Aditya
Ed Merks
Professional Support: https://www.macromodeling.com/
|
|
|
Powered by
FUDForum. Page generated in 0.03076 seconds