Skip to main content



      Home
Home » Eclipse Projects » DSDP - Target Management » serverPortRange recommendation
serverPortRange recommendation [message #580177] Wed, 01 April 2009 11:20
Eclipse UserFriend
Last April we had a thread going where we talked about how many ports
might be wise to provide for the serverPortRange when running the dstore
daemon (perl ./daemon.pl [daemonPort] [serverPortRange]) for 100-150
clients or more. Here is a snippet of the last response from David
McKnight
http://www.eclipse.org/newsportal/article.php?id=378&gro up=eclipse.dsdp.tm#378

"I talked to a couple of those product teams today and they told me
they'll
get back to me on what they set for their port ranges. The reason you
need
more than one is because multiple clients may attempt to connect at the
same
time (requiring multiple sockets to wait for connect). The higher the
number of users, the more likely it is that two connects will happen at
the
same time."

Anyway, I was hoping I could find out what folks out there use for the
serverPortRange for the dstore daemon for large sets of users. Thanks!
Previous Topic:Invalid project path: Include path not found
Next Topic:Block-mode using RSE
Goto Forum:
  


Current Time: Sat Jul 05 08:55:19 EDT 2025

Powered by FUDForum. Page generated in 0.22674 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.2.
Copyright ©2001-2010 FUDforum Bulletin Board Software

Back to the top